Perlite thermal insulation mortar

Perlite thermal insulation mortar is uses the inorganic gelled material to mix has many kinds of admixtures, melts the micro ...

product outline:

Perlite thermal insulation mortar is uses the inorganic gelled material to mix has many kinds of admixtures, melts the micro bead lightweight aggregate with Bolivia the inorganic heat preservation mortar which makes through the premix dry mix.

Second. Product characteristic:1) The thermal conductivity is small, the heat preservation effect is good2) the water resistance is good, the air shrinkage rate is small 3) Static pressure shearing force 4) Touches changes, the workability is good5) Construction thickness easy to control, construction compatible6) Bears the freezing and thawing performance to be good, the stable property is durable7) The wind resistant piezotropy can be good 8) The environmental protection, difficult to burn the rank to be highThird. Applicable scope:Mainly uses in each kind of building wall the wall, the roofing and the ceiling heat preservation. May also keep warm the compound system with the highly effective thermal insulation material constitution outer wall outside.Fourth, product performance:

Does the apparent density (kg/m3) ≤300 the thermal conductivity (W/mK) ≤0.065Wet apparent density (kg/m3) ≤680 linear shrinkage (%) ≤0.3Compressive strength (MPa) ≥0.30 tensile strength (MPa) ≥0.15Cohesional strength (MPa) ≥0.1 softened coefficient ≥0.60Set time prehardening ≥1.0 Final set ≤2.0Regeneration coefficient (w/.k) ≥0.9 Fifth, application method:The ingredient joins the 15kg water first in the mortar agitation barrel (visible special details adjustment), joins a bag of SL Bolivia to melt the micro bead heat preservation rubber mortar, after stirring 1-2min forms the even glue, then carries on the construction.Job practice:

1. uses the trowel to carry on smudges.2. before the construction, should find thickness reference point, available stirs the good heat preservation pulp to paste the cake, to flush the muscle, the heat preservation pulp plastering weight spreads the construction, each plastering thickness should be smaller than 10mm, when the plastering the gap should be 12h, the landing ash may clean up the redundant use promptly.Sixth, matters needing attention: 1) constructs the temperature not to be lower than 5, after the heat insulating layer solidifies approximately 2d, dry (with palm according to motionless for suitable), carries on the protection surface layer again the construction. 2) stirs the good heat preservation pulp to use up in 1h, forbids to use the obsolete ash.

Seventh, packing and storing:

1st, in this dried noodles mortar knitting bag the peritoneum packing, the pellet weaves the bag packing.

2nd, please open-air depositing, do not prevent to be affected with damp.

Perlite thermal insulation mortar